The physical properties of the NOMARK PLUS engraving material are largely controlled by the base material. This material was chosen to provide a good balance of properties for this product to satisfy a wide range of uses.

The material softens at about 200oF (93.00oC) sufficiently so that it can be bent where needed. It can be drilled, sawed, sheared, nailed, bonded and die-cut.

The base material, as well as the foils, were tested for flammability by Underwriters Laboratories. The base material is rated as 94 HB on the UL 94 test. The foil was judged as not contributing to combustion of the base.

Most of the colors will exhibit slight fading under prolonged exposure to direct sunlight. There are, however, those which tend to fade more severely. This material is designed for use where no direct extreme exposure is encountered.

Note: The above information is given in good faith, but no warranty, express or implied, is give.

1.6ft lbs/in

D-256

To Break

4200 psi

D-638

8000 psi

D-790

Rockwell Hardness

D-785

Temperature at which Material Deflects .254mm at 264 psi

D-648